Product description

This 3/8-inch high-pressure hydraulic hose, spanning 238 inches in length, is a primary fluid conduit for John Bean and Snap-On automotive lifts. Designed to deliver hydraulic power from the pump unit to the lifting cylinders, this hose is engineered to withstand the extreme pressures required to raise thousands of pounds. The multi-layer construction features high-tensile wire reinforcement to prevent expansion or bursting under load, while the synthetic rubber cover provides resistance to abrasion and common automotive fluids. A hose of this length is typically used in overhead crossmember applications where fluid must travel from the power column to the far-side slave cylinder. Ensuring the integrity of hydraulic lines is the most critical maintenance task for any hydraulic lifting system.

Product highlights

• High Pressure Performance: Engineered for the demanding fluid power requirements of heavy-duty vehicle lifts.
• Wire Reinforced: Multi-layer construction ensures minimal expansion and maximum burst protection.
• Chemical Resistant: Outer cover protects against hydraulic fluid, oil, grease, and shop chemicals.
• Extended Reach: 238-inch length suitable for crossing wide lift spans and reaching remote cylinders.
• OEM Fitment: Designed to replace the factory hose on Snap-On and John Bean lifting equipment.

Specs

• Length: 238"
• ID (Inside Diameter): 3/8"
• Manufacturer: John Bean (Snap-On)
• Manufacturer Part Number: JBC22336000
• Country of Manufacture: USA

Direct replacement models

John Bean / Snap-On JBC22336000

You will receive the same product or an OEM-Equivalent that meets the highest standard of the OEM with warranty that will be a direct-fit. Manufactured with rigorous industry standards and certified in the USA with superior quality to the OEM.